China Slurry Pumps, Warman Pumps and Warman Slurry Pump Parts Manufacutrer in China - Tobee Pump 180 3203 4573

Centrifugal Slurry Pump Overheated Problems

Jan 08, 2018

AH slurry pumps are most common and maximum utilization of slurry pumps. AH slurry pump is designed by Weir minerals, which with simple structure and durable working life. Hope what we talked bellow could help you solve motor overheat problems you may have in maintenance process of AH slurry pumps.

Slurry Pump Overheating Reasons

Slurry Pump Overheating Solutions

Slurry pump working under overflow condition, too larger than designed flow point.

Turn down outlet valve or other ways to decrease slurry pump flow.

Slurry pump speed is too high. The slurry pump speed too high will need more shaft power, increasing pump burden

Reduce the slurry pump speed.

Slurry pump seal ring wear problem. Slurry pump seal ring wear too much will lead to adhesion to the shaft, causing overheat of shaft.

Replace the seal ring and increase lubrication efforts.

Slurry liquid density is too high. The density is too large, resulting in pump pressure increased, it will increase the burden on slurry pump itself.

Increase motor power.

Slurry pump rotating parts friction. The distance between the various components of the slurry pump is limited.

Make sure all clearance of slurry pumps installed in accordance with specifications, eliminating friction.

Bad quality motor. It may be aluminum motor or inside winding relatively is small.

Use better motor. Remember to use good motor all the time, do not use defective products.

Slurry pump packing is too tight. Too tight packing may lead to dry running of slurry pumps phenomenon, will seriously hamper the operation of slurry pump.

Loose slurry packing filler to reduced pressure.

Technical dept.
Hebei Tobee Pump Co.,Limited

Contact Us

Copyright © 1987-2017 Tobee® Pump. All Rights Reserved

* * *