Professional Slurry Pumps, Warman Pumps and Slurry Pump Parts Manufacutrer in China - Tobee Pump
Sales@tobeepump.com+86 180 3203 4573

China WN Dredge Pump Introduction & Advantages

Jan 25, 2018

China Heavy Duty Sand Dredging pump

Construction
WN200 to WN500 dredge pumps are of single casing, single stage cantilevered horizontal centrifugal dredge pumps. Two types of coupling with gear box: frame and pump box.
WN600 to WN1000 dredge pumps are of double casings, single stage cantilevered centrifugal dredge pumps.
The WN series dredging pumps are equipped with frame and lubrication is force thin oil. The design of double casing the dredge pump working till the volute liner almost worn down and guarantee no leakage when volute liner is worn down.

Easy Uninstallation & Convenient Maintenance
WN dredge pump is of front uninstallation construction to make uninstall easily and convenient
maintenance. And special tools are equipped for uninstalling the parts.
Standard four-head trapezoid thread connection between impeller and shaft can transfer powerful torsion and be convenient to uninstall. Impeller uninstall ring at shaft sleeve side also make the impeller uninstallation much easier.

Good Performance
• Good NPSH can not only guarantee suction but also make deep dredge and high allowable suction density. Minimum NPSH: 4m.
• With wide impeller passage, pump can continuously pump gravel or high plastic clay without clogging.
• Max allow particle size: 350mm.
• Performance curves descend obviously to make pumps adopt pipeline distance changes.
• By changing the impeller diameter or impeller rotating speed, it can easily change the discharge with the same flow rate.

Material
• Material of wet parts is high wear resistant high chrome alloy.
• Considering the maintenance, wear resistant parts are nearly of the same wear life to reduce maintenance & interchange costs.

Low Hydraulic loss, High efficiency, Energy Saving
• Efficiency of WN is 2 or 3 percentage higher than other common pumps.
• Reliable Shaft Seal, No leakage
• Shaft Seal types of WN200 to WN500: Mechanical seal, packing, or combination of mechanical and packing
• WN600 to WN1000 uses helical casing L rubber seal which is made of 3 pieces of L seal ring and one special thread shaft sleeve.

Turning
WN700 to WN1000 can be equipped with turning to change rotating directions.

Technical dept.
Hebei Tobee Pump Co.,Limited

Contact Us

Copyright © 1987-2017 Tobee® Pump. All Rights Reserved

* * *
Top